11
USING YOUR SMART AIR PURIFIER (CONT.)
Air Quality Indicator Chart
Indicator
Color
Clean Air
Percentage Range
Air
Quality
Auto Mode
Fan Speed
Blue
90–100%
Very Good Sleep Mode
Green
80–89%
Good Low
Orange
70–79%
Moderate Medium
Red
0–69%
Bad High
Air Information
Clean Air Percentage
PM Values
Note:
• The air purifier will take 5 seconds
to detect the air quality each time it
is turned on. During this time, the air
quality indicator rings will be blue. After
5 seconds, the air quality indicator
rings will change color based on the
detected air quality.
• Auto Mode does not use the Turbo
Mode.
• The VeSync app also supports ECO
Auto Mode (see page 14).
Note: The percentage is approximate. The
sensor can only detect airborne particles, not
odors or gasses.
Your air purifier automatically scans your air
and analyzes the quality. By default, the air
purifier shows the overall clean air percentage
on the center of the display.
1. Tap to change the air quality
information shown on the center of the
display.
2. Keep tapping to cycle through air
quality readings for PM1.0, PM2.5, PM10,
and overall clean air percentage. For more
information, see PM Values (page 11).
3. When you stop tapping , the
current air quality reading will stay on the
display until you restart the air purifier.
If you restart the air purifier, the display
will again show the overall clean air
percentage.
Clean air percentage is an estimated
measurement of the amount of clean air in the
room, between 0% (bad) to 100% (very good).
This percentage is calculated by an algorithm,
based on:
• The concentration of particles detected in the
air, including micro-particles.
• The change in detected particles in the air
during purification.
“PM” stands for “Particulate Matter,” and usually
refers to airborne particles floating in your air,
including dust and most allergens. Many of
these particles are too small to be seen with
the naked eye, and without air purification,
they stay in the air much longer than heavier
or larger particles.
Your air purifier’s AirSight Plus 2.0 Laser
Dust Sensor detects the amount of airborne
particles that are in a given space (g/m).
Generally, the lower the number, the better
your air quality.
To Next Page
Loading...
