I. Additional tips for card health
1. When using the card on a different camera, format the card on the new camera or
through the card reader. Please back up the data in the card before formatting.
2. Do not remove the card while data is being written to the card to avoid incomplete
data capture.
3. Do not pull out or insert the card while the power is on, to avoid damage to the card
or loss of data.
4. If your device gets too warm, please pause the shooting process until your device
cools down. This will keep your device within an acceptable operating temperature.
a) For environment temperature, please refer to the high temperature standard of
the meteorological station.
b) For the product temperature, if the high temperature warning appears in the
camera shooting display, please pause the shooting process until your device
cools down.
II. Always use a card reader
When reading or transferring content to your computer we recommend using a
matching an UHS-I or UHS-II card reader that matched your card performance. We also
recommend using a Lexar Card Reader for additional compatibility as 3
rd
party readers
may not meet the rated specs as defined by Lexar products.
To Previous Page
Loading...
