5-8
Lexicon
300L Owner's Manual
P69 VOCAL SHEEN SoftSlider: SPACE 50
A great “dry addition” to rock and roll vox tracks. The SoftSlider controls Room Size, Reverb time,
and Reverb Level. Advance the SoftSlider for slower ballad type tunes.
P70 ALMOST VERB SoftSlider: PREDELAY 50
As the name suggests, there’s a fine line here. Somewhat lacking in high frequency content with the
SoftSlider mapped to the predelay parameter.
P71 RICH PLATE SoftSlider: DECAY 48
An old standard, bright and diffuse. Advancing the SoftSlider controls the reverb time.
P72 GLOSSY PLATE SoftSlider: DECAY 75
This preset shines a little differently. Some close in pre-echoes give a strong impact to the original
source. Great for stereo horn sources.
P73 WARM PLATE SoftSlider: DECAY 60
Not your average bright plate — rather a slightly dull version which will work very well on orchestral
tracks, adding point and definition.
P74 PERC PLATE SoftSlider: SIZE 64
For drums and the like. Not bad on piano either. Bright and tight with the SoftSlider controlling the
Room Size.
P75 CONTEM-PLATE SoftSlider: DECAY 65
Bright and splashy-sounding. Should work well to brighten a track without getting too washy-
sounding.
P76 EKO PLATE SoftSlider: EKO DELAY 66
Combines a sweet combination of recirculating pre-echoes and bright sounding reverb. The
SoftSlider is negatively patched to RTIM and Delays 1 and 2.
P77 5K HALL SoftSlider: DECAY 64
This preset takes a little getting used to but has that different texture which helps to punch through
a mucky mix. Use the SoftSlider to vary the Mid Rt decay.
P78 ROUND PLATE SoftSlider: DECAY 55
Soft, but articulate. The SoftSlider is patched to feedback paths surrounding pre-echoes 1 and 2,
which feedback into the reverberator.
P79 SALAD PLATE SoftSlider: DECAY 65
Smaller than a dinner plate. Very bright, and somewhat thin. Medium RT.
P80 VOX PLATE SoftSlider: DECAY 60
This preset is made for adding a presence to the lead vocal track. Use the SoftSlider to match the
decay with the tempo and mood of the music.
P81 STEREOADJUST SoftSlider: LEVEL 98
Sets you up to fix audio sources. Null preset with controls for EQ, delays, phase and channel swaps,
and DC offset removal. The SoftSlider controls the Digital Master Level parameter.
P82 STEREO DELAY SoftSlider: DELAY 40
390 ms of delay with the initial SoftSlider preset value. Straight ahead with no feedback.
P83 3 FRAME DLY SoftSlider: FINE DELAY 70
100 ms of delay at both operating frequencies.
P84 4 FRAME DLY SoftSlider: FINE DELAY 70
133 ms of delay at both operating frequencies.
P85 PHASE INVERT SoftSlider: PHASE 64
The right channel is phase reversed to the left. The SoftSlider is mapped to the Right Channel Flip
and Swap. 0-32 is stereo in phase. 33-64 is L-R, 65-96 is R,L (channel swap), and 97-127 -R,L. If
you put a mono signal into both the left and right inputs and pan the output returns left and right, you’ll
definitely twist your head off as well as matrix L-R to the surround channel. NOT MONO
COMPATIBLE
NOTE: This phase-reversed mono signal will decode to the surround channel if run through a
surround decoder.
To Next Page
Loading...
