Lexicon 300L - REV 1 - Programming Parameter Glides

Lexicon
300L Owner's Manual
6-6
-24 18 12 6 0 6 +12 ovld dB
L
R
-24 18 12 6 0 6 +12 ovld dB
L
R
Programming
Parameter Glides
Parameter glides can be a very powerful automation feature, allowing, for
example, reverb time increases at the end of a commercial, automated fade-
outs, EQ changes, or feedback levels.
The last three selections available with the TYPE slider on the Event Edit page
are:
MA: GLIDE
MB: GLIDE
S: GLIDE
Selecting any of these, causes two additional sliders, labeled VAL and DUR to
become active.
EDIT TC TYPE SEL VAL DUR
All the available parameters for the previously loaded Machine Effect or Setup
are available via the SEL slider.
As an example, suppose the first event in the event list is to load Setup 102 REV/
DLY.
For event #2, we’ll specify a parameter glide for Machine A. To do this, move
the TYPE slider until the upper display shows:
#2 MA: GLIDE
n n : n n : n n : n n
Use the SEL slider to select REVERB TIME. The upper display should show:
#2 MA: GLIDE
M ID RT
then will revert to the display of time code value after 2 seconds.