Lexicon MC-12 EQ - REV 1 User Manual

Configuring the MC-12 for EQ
2-9
EQ User Guide
The CHECK MICROPHONES results
screen (shown to the right) opens on
the on-screen display when the MC-12
finishes checking the microphones. This
screen provides the results for each
microphone. (The MC-12 refers to the
microphones as 1, 2, 3, and 4 based on
the microphone input connector to
which the microphone is connected.)
• OK indicates that the microphone passed the microphone
check.
• ERROR indicates that the microphone did not pass the
microphone check.
4. Press the  and  arrow buttons to highlight the desired
microphone.
5. Press the  arrow button to view more detailed results for the
selected microphone. The CHECK MICROPHONES Results table
on the next page describes all possible results.
Once a successful microphone check has been
performed:
• The MC-12 retains the determined microphone level until
the SPEAKER SETUP menu is closed. Once this menu is
closed, another microphone check is required before automatic
calibration can be performed.
CHECK MICROPHONES
MIC 1 ERROR
MIC 2 OK
MIC 3 OK
MIC 4 OK
PRESS V TO VIEW
DETAILS
PRESS X TO CONTINUE
MIC 1 ERROR
• Do not disconnect the microphones from the microphone
input connectors. If the microphones are disconnected,
perform the microphone check again before performing
automatic calibration.

Lexicon MC-12 EQ - REV 1 Specifications

General

Brand	Lexicon
Model	MC-12 EQ - REV 1
Category	Controller
Language	English