3-4
Lexicon MRC V4.0/ MIDI Remote Controller
4. Confirm that the LXP-15 is set to receive on the same MIDI channel as
the displayed “CH#”.
5. Press ENTER to put the MRC into Machine Run Mode. The MRC
display will change to show the first page of LXP-15 Setup parameters.
6. Press ✱ to send the MRC Setup parameters to the LXP-15. The
parameter values displayed by the LXP-15 will change to match those
displayed by the MRC. (This step only needs to be done the first time
communication is established between the two units.)
7. You can confirm that one-way communication has been established by
moving a parameter slider on any of the six MRC parameter pages. The
LXP-15 display for that parameter should change to match the new
value.
In order to see parameters change on the LXP-15 when MRC sliders are
moved, set the LXP-15 “Update” parameter to “ON”, turn PAGE to the
appropriate parameter page, and press VIEW to display the parameter
values.
With one-way communication, the MRC has no way of “knowing” if the
current LXP-15 setup or parameters have been changed. (This could
happen for example, by sending a Program Change message to the LXP-
15 or by changing parameters or setups from the LXP-15 front panel.) If you
think the LXP-15 has been changed by some other action, simply press the
✱ key on the MRC to transmit the current MRC values to the LXP-15.
To Next Page
Loading...
Need help?
General