3-21
Controlling the LXP-15
Owner's Manual Addendum
3. Transmit the changes to the LXP-15, but don’t store them.
Option 1 is available to you at any time while in etup Edit Mode. Simply press
MACH to cancel any changes and return to Machine Run Mode.
The other options are accessed by pressing either STORE or ENTER. The
display will show the following message:
STORE BEFORE EXITING?
1>Yes 0>No 2>Re-edit
Pressing 1 will store the edited setup into the internal or external setup
location selected on page 2, transmit all parameters to the LXP-15 and
return you to Machine Run Mode.
Pressing 0 will transmit all parameters to the LXP-15 (including changes you
made while in Setup Edit Mode) and return you to Machine Run Mode. Note
that the edited setup is
not
stored in an internal or external register. At this
point, you can store the edited setup into a new location from Machine Run
mode. (See
Storing Setups from Machine Run Mode
)
Pressing 2 returns you to Setup Edit mode. No parameters are stored or
transmitted.(You can also press MACH to return to Machine Run Mode
without storing or transmitting any parameters.)
To Next Page
Loading...
Need help?
General