2-13
Basic Operation
PCM 91
3.1 Receive
Turn ADJUST to select OFF, 1-16, or OMNI for receipt of MIDI
messages.
3.2 Transmit
Turn ADJUST to select OFF, or 1-16 for transmission of MIDI
messages.
3.3 Pgm Change
This control specifies the PCM 91's response to incoming MIDI
Program Change messages. There are four selections available via
ADJUST: On, Off, Map and Chain.
Pgm+ and Pgm –, are available as subparameters in each location.
Pgm+ will load the next higher effect in the current bank, map , or
chain. Pgm – will load the next lower effect. You can select the
following sources to activate Pgm+ and Pgm –:
Off
Footswitch 1
Footswitch 2
•
•
•
MIDI Controller #119.
On
Program Change messages 0-49 correspond to PCM 91 Effects 0.0-
4.9 in the current bank. Program Change messages 50—127 are
ignored. The current bank can be changed with MIDI Continuous
Controller 32 and Bank Select Messages as follows:
• 0–8: Program Banks 0–8
• 9-10: Internal Register Banks 0-1
• 11-15: reserved for ROM Card Banks
• 16-24: Memory Card Banks. The number of banks
available on a given card will vary with its size,
as follows:
Card Size # Banks
64 1
256 5
512 10
1 Meg 20
Off
All Program Change and Bank select messages are ignored.
Map
Program Change 0-127 can be mapped to any PCM 91 effect in
any internal or card bank. Two 128 element maps are stored
internally, additional maps may be stored on RAM cards. Once you
have selected Map, press Load/✱ to display:
MIDI Pgm Change
3.3 ✱Map Select 0
Turn ADJUST to select the desired Program Change Map.
To Next Page
Loading...
