2-14
Basic Operation
Lexicon
ROW 3 MIDI (continued)
Chain
Any Program Change number can be selected to load any one of
ten customized effect “chains". Additional chains can be stored on
RAM cards. Once a chain is loaded, effects in the chain are accessed
by the controller patched to Pgm + and Pgm – (program increment
and program decrement). Once you have selected Chain, press
Load/✱ to display:
Automation sends all MIDI commands in PCM 90 format which
can be received by either a PCM 90 or a PCM 91. This means that
Automation mode can control both PCM 90s and PCM 91s, and
that a PCM 90 can control a PCM 91 in Automation mode. As the
PCM 90 does not have banks 5-8, it will not recognize programs
from those banks in Automation mode.
3.5 Send (Foot Pedal, Foot Sw 1, Foot Sw 2, ADJUST)
If Transmit is set to On these controls can transmit MIDI controller
messages. Press Load/✱ to cycle through the controller selections.
Use ADJUST to select the MIDI Controller message to transmit.
Receipt of MIDI Controller messages will affect the PCM 91 in the
same manner as if the internal controls were adjusted.
3.6 Int Clock
You can choose to have the PCM 91 transmit MIDI Clock at the
current tempo rate by setting this control to On and Tempo mode
Source (0.2) to Internal. If this control is set to Off, MIDI Clock will
not be transmitted.
3.7 SysEx
This control is provided for communication with one or more
additional PCM 91s or computer editor software. On (the default
setting) allows SysEx messages to be received by the PCM 91.
Press Load/✱ to select device ID (0-126 ).
3.8 Dump
Press Store to configure the PCM 91 to execute MIDI dumps of
single effects, banks, maps, chains, or setups. With the exception of
Setup Dumps, all dumps are transmitted in PCM 90 format, which
is also recognized by the PCM 91. You can dump from the front
panel of either unit to the other. As the PCM 90 has only five Banks
MIDI Pgm Change
3.3 ✱Chain MIDI
MIDI Pgm Change
3.3 ✱Chain 3
Turn ADJUST to select the desired Program Chain. When set to
MIDI, Program Chains will be loaded by MIDI Program Change
messages according to the settings of Chain Pgm Assign in Row 6.
To load a specific Program Chain, without sending the PCM 91 a
MIDI Program Change message, use ADJUST to display the desired
chain number.
3.4 Automation
This control is provided to allow one PCM 91 to act as a master for
any number of slaved PCM 91s. Select On to have values resulting
from front panel operations sent out as SysEx messages. Press
Load/✱ to select the ID (0-126 or All) of the target PCM 91(s).
To Next Page
Loading...
