2-15
Basic Operation
PCM 91
(0-4), references to Banks 5-8 will be ignored when transmitted to
a PCM 90.
3.9 Dump Speed
Turn ADJUST to select dump speeds of Slow, Medium or Fast to
achieve compatibility with the connected MIDI device.
ROW 4 SETUP
4.0 STORE
Control mode Audio, System, and MIDI parameter settings, along
with two settings from the Tempo matrix, comprise a "Setup." Five
setups can be stored and named in the unit, or on a Memory Card,
allowing you to transport not only your effects, but complete PCM
91 environments to another PCM 91. Press Store to initiate the
Setup Store function.
When the PCM 91 is shipped (or when you reinitialize the unit)
default values are assigned to these parameters. The following
table shows the Setup parameters along with the factory default
setting of each parameter.
4.1 Load
This control allows you to load any of five stored setups, restore the
factory default setup shown at the right, or load a setup from a
Memory Card. Press Load/✱ to cycle through the selections.
(Memory Card selections will only appear when an appropriate
card is inserted.)
4 4.0 4.1
Setup
Store Load
Control Mode
Matrix Location System Parameter Default Setting
Audio 0.0 Input Source Analog: 48kHz
0.1 SCMS Multi Copy
0.2 Emphasis Bit Pass Thru
0.3 Output Level +4dBu
System 1.0 Edit Mode Go
1.1 Mix Mode Pgm
Global Mix Value 100% Wet
1.2 Tempo Mode Pgm
Global Tempo Value 120 BPM
1.3 Bypass Mode InputMute
Bypass Src Off
1.4 Pgm Bypass AllMute
1.5 Mem Protect Off
1.6 Auto Load Off
1.7 Patch Update Delayed
1.8 KeyWord On (A to Z)
MIDI 3.1 Receive OMNI
3.2 Transmit 1
3.3 Pgm Change On
Pgm+ Off
Pgm– Off
Map select 0
Chain MIDI
3.4 Automation Off
3.5 Footpedal None
Sw 1 None
Sw 2 None
ADJUST None
Custom 1-4 None
3.6 Int Clock Transmit Off
3.7 SysEx Receive On
Device ID 0
3.8 MIDI Dump Current Program
3.9 Dump Speed Slow
Tempo Mode
Matrix Location System Parameter Default Setting
Tempo 0.2 Source Internal
Tap 1.3 Display On
To Next Page
Loading...
