Lexmark 350 Series - Cannot Print from Digital Camera Using Pictbridge; Removing and Reinstalling the Software

5 Plug the power supply cord into the wall outlet.
6 Press to turn the printer back on.
Cannot print from digital camera using PictBridge
S
OLUTION 1
Enable PictBridge printing on the camera by selecting the correct USB mode. For more information, see the digital
camera documentation.
SOLUTION 2
1 Disconnect the camera.
2 Connect a PictBridge-enabled digital camera to the PictBridge port. See the digital camera documentation to
determine whether it is PictBridge-enabled.
SOLUTION 3
Use only the USB cable that came with the camera.
SOLUTION 4
Remove the memory card or the flash drive from the printer.
Removing and reinstalling the software
If the printer is not functioning properly, or if a communications error message appears when you try to use the
printer, you may need to remove and reinstall the printer software.
1 Click Start  Programs or All Programs  Lexmark 350 Series.
2 Select Uninstall.
3 Follow the instructions on the computer screen to remove the printer software.
4 Restart the computer before reinstalling the printer software.
5 Click Cancel on all New Hardware Found screens.
6 Insert the CD, and then follow the instructions on the computer screen to reinstall the software.
12