Lexmark 350 Series - Setting the Bluetooth Mode

3 Insert a USB Bluetooth adapter into the PictBridge port on the front of the printer.
Note: Bluetooth adapter sold separately.
4 Once the printer detects the Bluetooth adapter, the following message appears on the printer display for five
seconds: Bluetooth Dongle Connected.
5 To print photos from your Bluetooth-enabled device, see the documentation that came with the product.
Note: To prevent smudging or scratching, avoid touching the printed surface with your fingers or sharp objects.
For best results, remove each printed sheet individually from the paper exit tray, and allow the prints to dry at
least 24 hours before stacking, displaying, or storing.
Related topics:
• “Setting the Bluetooth mode” on page 20
Setting the Bluetooth mode
1 Press or repeatedly until Tools appears on the display.
2 Press .
3 Press or repeatedly until Bluetooth appears.
4 Press .
5 Press or repeatedly until Bluetooth Enable is selected.
6 Press or to select either On or Off.
7 Press or repeatedly until Discovery Mode is selected.
8 Press or to select either On or Off.
9 Press to save your selection.
Related topics:
• “Printing using Bluetooth” on page 19
Using the printer
20