4 Close the access cover, and then open the front door.
5 Release the two latches (C), and then disengage the middle front part (D) of the cover from the front door.
Warning—Potential Damage: The ADF might swing open while you position the printer on its side.
C
D
C
6 Remove the cover.
Interconnect cable removal
1 Remove the right cover. See “Right cover removal” on page 223.
2 Position the printer on its rear side.
Warning—Potential Damage: The ADF might swing open while you position the printer on its side.
3 Disconnect the cable JOPT1 from the controller board.
4 Remove the three screws (A).
7017-2xx, -4xx, -6xx
Parts removal
225
To Next Page
Loading...
