Operator panel assembly removal (model X658)
Warning—Potential Damage: When replacing the operator panel assembly or the system card assembly,
only replace one component at a time. Replace the required component and perform a POR before replacing
another component. If this procedure is not followed, the printer will be rendered inoperable. Never replace
two or more components without a POR after installing each one or the printer will be rendered inoperable.
Never install and remove the components as a method of troubleshooting components. Once a component
has been installed in a machine, it cannot be used in another machine. It must be returned to the
manufacturer.
1 Pull the operator panel door assembly forward, and remove.
2 Remove the two screws (A) securing the USB port to the operator panel door assembly.
A
7462
Repair information
349
To Next Page
Loading...
