Serial <x>
The printer is using a serial cable connection. The serial port is the active communication link.
Some held jobs were not restored
Press until Continue appears, and then press to delete the specified job.
Some held jobs will not be restored
• Press until Continue appears, and then press to clear the message and resume printing.
• Cancel the current job.
Standard Bin Full
Remove the stack of paper from the standard exit bin to clear the message.
Staples <x> empty or misfed
Load the specified staple cartridge into the finisher to clear the message and continue stapling.
Staples <x> low or missing
Load the specified staple cartridge in the finisher to clear the message.
Submitting Selection
Wait for the message to clear.
Tray <x> Empty
Load paper in the tray to clear the message.
Tray <x> Low
Load paper in the specified tray to clear the message.
Tray <x> Missing
Insert the specified tray into the printer.
USB/USB <x>
The printer is using a USB cable connection. The USB port is the active communication link.
Understanding printer messages 120
To Next Page
Loading...
