35 Insufficient memory to support Resource Save feature
• Press until Continue appears, and then press to disable Resource Save and continue printing.
• To enable Resource Save after receiving this message, make sure the link buffers are set to Auto, and then exit the
menus to activate the link buffer changes. When Ready appears, enable Resource Save.
• Install additional memory.
37 Insufficient memory for Flash Memory Defragment operation
• Press until Continue appears, and then press to stop the defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
37 Insufficient memory to collate job
• Press until Continue appears, and then press to print the portion of the job already stored and begin
collating the rest of the print job.
• Cancel the current print job.
37 Insufficient memory, some held jobs will not be restored
The printer was unable to restore some or all of the confidential or held jobs on the printer hard disk.
Press
until Continue appears, and then press to clear the message.
38 Memory full
• Press until Continue appears, and then press to clear the message.
• Cancel the current print job.
• Install additional printer memory.
39 Page is too complex to print
• Press until Continue appears, and then press to clear the message and continue printing.
• Cancel the current print job.
• Install additional printer memory.
50 PPDS font error
• Press until Continue appears, and then press to clear the message and continue printing.
• The printer cannot find a requested font. From the PPDS menu, select Best Fit, and then select On. The printer will
find a similar font and reformat the affected text.
• Cancel the current print job.
Understanding printer messages 122
To Next Page
Loading...
