PJL
3-48
Printer Unique Variables for PCL Emulation
The following variables are unique to your printer and are supported in PCL emulation
only. The
[command modifier:value] parameter should be specified as LPARM:PCL.
For example:
@PJL SET LPARM:PCL LBITMAPROUNDING=OFF[<CR>]<LF>
To determine which variables your printer supports, see Table B-4: “Printer Unique
Variables for PCL Emulation” on page B-12.
Table 3-6: Printer Unique Variables for PCL Emulation
Variable Function Selections Factory Default
LA4WIDTH A4 Width in
millimeters
198, 203 198
LASSIGNFEEDER Tray Renumber
Assign Envelope
Feeder
OFF,0to199
Variable used with PJL SET or DEFAULT
command.
OFF
OFF,0to199,NONE
Variable used with PJL INQUIRE or DINQUIRE
command.
OFF
LASSIGNMANUALENVELOPE Tray Renumber
Assign Manual
Envelope
OFF,0to199
Variable used with PJL SET or DEFAULT
command.
OFF
OFF,0to199,NONE
Variable used with PJL INQUIRE or DINQUIRE
command.
OFF
LASSIGNMANUALPAPER Tray Renumber
Assign Manual Paper
OFF,0to199
Variable used with PJL SET or DEFAULT
command.
OFF
OFF,0to199,NONE
Variable used with PJL INQUIRE or DINQUIRE
command.
OFF
LASSIGNMPFEEDER Tray Renumber
Assign Multipurpose
Feeder
OFF,0to199
Variable used with PJL SET or DEFAULT
command.
OFF
OFF,0to199,NONE
Variable used with PJL INQUIRE or DINQUIRE
command.
OFF
To Next Page
Loading...
