PCL
2-10
Font and Symbol Set Support for the Lexmark C720,
T520, T522, T620, T622, and W820
Your printer has 86 resident fonts in PCL emulation, including 84 scalable fonts and
two bitmapped fonts.
Several parameters are used to select a font from the data stream. These include
symbol set, spacing, point or pitch, style, weight, and typeface number. For scalable
fonts, you can vary the size of a font by specifying pitch or point size. For bitmapped
fonts, you must choose the pitch or point size listed on the font sample pages. You can
print the font sample pages from the printer operator panel or through MarkVision
Professional. Refer to your printer user documentation for more information.
A
symbol set
defines which characters are available for a font and the code point for
each of these characters. Your printer supports 83 symbol sets. The tables beginning
on page 2-16 show the symbol sets available for each font in PCL emulation. Not all
fonts support all symbol sets.
You can select a font as the PCL emulation default from the printer operator panel or
through MarkVision Professional. Refer to your printer user documentation for more
information.
The fonts are divided into two major groups. The first 47 fonts (R0 to R46) shown on
the font sample pages are the standard PCL emulation fonts. The 39 remaining fonts
(R47 to R85) are called Type 1 fonts and were originally defined for PostScript
emulation, but now also work in the PCL emulation.
The fonts are further divided into font groups A, B, and C indicating which symbol sets
are supported by each font. For a list of the 47 standard PCL emulation fonts, see
Table 2-5 on page 2-12. For a list of the 39 Type 1 fonts, see Table 2-6 on page 2-14.
Both tables list the forward and backward compatibility font selection commands and
the font group (A, B, or C) for each font. For more information on forward and backward
compatibility, see page 2-12. For more information on selecting symbol sets, see
page 2-16.
For compatibility purposes, you can disable Type 1 fonts with the Printer Job
Language (PJL) LTYPE1FONTS command. The factory default for these fonts is
Enabled. See LTYPE1FONTS on page 3-46 for more information.
To Next Page
Loading...
