3 Take a photo of the signed form, and then upload it to the Service Request debrief tool.
4 Fax or e-mail the signed form to the number or e-mail address shown at the bottom of the form.
Performing the HVPS characterization
Make sure to perform the following procedure when replacing the HVPS.
1 Enter the Diagnostics menu, and then navigate to:
Reports > Device > Device settings
2 Take note of the HVPS adjust values.
3 Turn
o
the printer.
4 Remove the old HVPS.
5 Install the new HVPS.
6 Perform a POR.
7 Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments > HVPS adjust
8 For each letter under the HVPS adjust section, enter the values as indicated on the sticker of the new HVPS.
9 Perform a POR.
10 Enter the Diagnostics menu, and then navigate to:
Reports > Device > Device settings
11 Check if the new HVPS adjust values were saved.
3400-48x
Parts removal
226
To Next Page
Loading...
