Lexmark MB2338 - Page 167

Error code Description Action
887 Failure to transmit training successfully in
V27 terminal modulation scheme.
• Decrease the Max Speed setting
under Fax Send settings.
• Adjust the Transmit Level setting.
• Check line quality.
888 Failure to transmit training successfully at
2400 bps in V27 terminal modulation
scheme.
• Adjust the Transmit Level setting.
• Check line quality.
889 Failed to connect at the minimum speed
supported by the MFP.
• Adjust the Transmit Level setting.
• Incompatible connection.
88A Failed to connect using V.34 modulation
scheme.
• Check line quality.
• Decrease the modulation scheme.
• Adjust the Transmit Level or Receive
Threshold settings.
901 No fax tones detected from remote end.
• Verify destination phone number.
• Verify that the remote fax is
authorized to receive faxes.
902 No dial tone detected.
• Check by enabling Behind a PABX
setting.
• Check phone line.
• Check MFD modem hardware.
903 Busy tone detected. Check with remote end if successive
attempts fail.
904 Hardware error detected. See
“Modem/fax card service check”
on page 158.
905 A timeout occurred after dialing the
number and waiting for a response.
Check with remote end if successive
attempts fail.
906 Fax cancelled by user. No action needed.
907 Modem detected a digital line connection. Verify that the MFP is connected to an
analog line. See
“Fax transmission
service check” on page 160.
908 Phone line was disconnected Restore phone line connection.
A00 Received request for unsupported
function from remote fax device.
No action needed.
A01 Received request for unsupported image
width from remote fax device.
No action needed.
A02 Received request for unsupported image
resolution from remote fax device.
No action needed.
A03 Received request for unsupported
compression type from remote fax device.
No action needed.
A04 Received request for unsupported image
length from remote fax device.
No action needed.
7017-2xx, -4xx, -6xx
Diagnostics and troubleshooting
167