Lexmark MS317 - Memory Low, no Resource Save [35]; Non-Lexmark [Supply Type], See Users Guide [33.Xy]; Network Error, Port [X] [54]

• Install additional printer memory.
Memory low, no Resource Save [35]
Try one or more of the following:
• From the printer control panel, press to disable Resource Save, clear the message, and continue
printing.
• Install additional printer memory.
Non‑Lexmark [supply type], see User’s Guide [33.xy]
Note: The supply type can either be a toner cartridge or imaging unit.
The printer has detected a non‑Lexmark supply or part installed in the printer.
Your Lexmark printer is designed to function best with genuine Lexmark supplies and parts. Use of third-
party supplies or parts may aect the performance, reliability, or life of the printer and its imaging
components.
All life indicators are designed to function with Lexmark supplies and parts, and may deliver unpredictable
results if third-party supplies or parts are used. Imaging component usage beyond the intended life may
damage your Lexmark printer or associated components.
Warning—Potential Damage: Use of third-party supplies or parts can
aect
warranty coverage.
Damage caused by the use of third-party supplies or parts are not covered by the warranty.
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your
printer, press
and on the printer control panel simultaneously for 15 seconds to clear the message
and continue printing.
If you do not wish to accept these risks, then remove the third‑party supply or part from your printer, and
then install a genuine Lexmark supply or part.
Note: For the list of supported supplies, see the “Ordering supplies” section of the User's Guide or visit
http://support.lexmark.com.
Network error, port [x] [54]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
• Unplug the router, wait for 30 seconds, and then plug it back again.
• Turn o the printer, wait for about 10 seconds, and then turn the printer back on.
• Update the network firmware in the printer or the print server. For more information, visit the Lexmark
Web site at
http://support.lexmark.com.
4514-330
Diagnostics and troubleshooting
109