Duplex sensor and input sensor (MX310, MX410) removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the right cover. See “Right cover removal” on page 226.
3 Remove the rear door and cover. See “Rear exit door removal” on page 301 and “Rear cover removal” on page
302.
4 Remove the power supply. See “Power supply removal” on page 272.
5 Remove the power supply shield. See “Power supply shield removal” on page 273.
6 Remove the duplex. See “Duplex removal” on page 274.
7 Disconnect the cable JDUPPI 1 from the controller board.
8 Remove the two screws (A), and cut the cable near the frame to detach the sensors.
A
9 Remove the other half of the cable from the printer.
Installation note: Route the cable using the new path, and secure it with a cable tie (A).
7015
Repair information
278
To Next Page
Loading...
