h Route the cable using the new path, and secure it with a cable tie (A).
A
ACM assembly removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the rear door and cover. See “Rear exit door removal” on page 301 and “Rear cover removal” on page
302.
3 Remove the power supply. See “Power supply removal” on page 272.
4 Remove the power supply shield. See “Power supply shield removal” on page 273.
5 Remove the duplex. See “Duplex removal” on page 274.
6 Position the printer so that it sits on its left side.
7 Remove the retainer spring (A).
8 Remove the spring (B).
7015
Repair information
288
To Next Page
Loading...
