36. Re-install the developer roller drive gear. Hold the gear
train and turn the gear until it locks. It’s a little hard to get on
now than if installed before, but it’s easier to install the hopper
this way. Either way is fine though.
37. Replace the chip by removing the screw and sliding the
chip out. When replacing the chip keep the contact side facing
the cartridge.
38. A shipping lock must now be installed. This lock should be
used even if you are going to hand deliver the cartridge. It will
prevent the toner hopper from coming in contact with the OPC
drum, and causing damage to either the drum or the develop-
er roller. Press the two red tabs into the sides of the cartridge
as indicated in the picture supplied with the lock.
LEXMARK T650 SERIES • TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
3232 West El Segundo Blvd., Hawthorne, California 90250 USA • Ph +1 424 675 3300 • Fx +1 424 675 3400 • techsupport@uninetimaging.com • www.uninetimaging.com
© 2009 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.
To Next Page
Loading...
