One-dimensional bar codes
14
PCL5 Emulation escape sequences
Command Function/Parameters
Esc
(s#P
or
AEC
)s#P
Determines the location of human-readable text printed with the bar code.
0 =
1 =
2 =
3 =
4 =
5 =
Use default value
Do not print text
Print text embedded
Print text half embedded
Print text under bar code
Print text above bar code
Add the numbers listed below to produce the corresponding effect:
10 =
10 =
20 =
100 =
Prints UPC-A checksum at middle left of the bar code instead of the
bottom left
Prints start/stop * characters with Code 3 of 9 text
Formats German postal bar codes
Prints the checksum character with text
For the UPC-E symbologies, checksum characters are always
printed if human-readable text is specified. The checksum
characters are printed half-height if 100 is added to the p
parameter, and are printed the same height as the text if 100 is not
added to the p parameter.
Example:
Esc
(s13p24670T
Selects Code 3 of 9 with human-readable text half embedded and start/stop *
characters. Because the v, b, s and h parameters are not specified, their values
default to:
v
b1, s1
b2, s2
h
.4 inch
.01 inch
.03 inch
automatically sized Courier Bold
To Next Page
Loading...
