Fonts
63
Fonts
The fonts provided by the Forms and Bar Code Card for emulation of JetCAPS BarDIMM Pro (Bar
Codes & More) are listed:
HRT Location (of
the linear
component)
int 0=Default
1=No HRT
2=Embedded
3=Half-Embedded
4=Under
Dependent on the
default HRT
Location of Linear
Component,
except for
UCC-128, which
uses Under as its
default value.
Corresponds to the HP #p parameter.
If an HRT Location of 5 (Above) is
specified, the bar code engine
automatically sets to HalfEmbedded.
Other invalid values will be set to the
default.
HRT Typeface (of
the Linear
Component)
int 0=Courier
1=SM Gothic
2=SM Unit
3=SM Unit
Condensed
4=Roman
5=OCRB
0 (dec) or 00 (hex) Optional.
Corresponds to the HP #h parameter.
Note: When the value given is not
within the defined range, the value will
be set to default (Courier).
Font Type Resides
Architext CMC7 Scalable On option card
CMC7 Scalable On option card
Code 39 - 4.69 Pitch Bitmap On option card
Code 39 - 8.11 Pitch Bitmap On option card
Code 39 Narrow Scalable In printer
Code 39 Regular Scalable In printer
Code 39 Wide Scalable In printer
Currency symbols (including
Euro)
Scalable On option card
Electrical symbols Scalable On option card
Line Draw Bitmap On option card
Manufacturing symbols Scalable On option card
MICR Scablable On option card
OCR-A Bitmap On option card
Field Name Type Range
Default (if not
specified)
Definition
The dimensions of the composite bar code may be varied in only two directions:
• The module height of the linear component is varied using the V parameter.
• The module width of the linear component is varied using the B parameter.
To Next Page
Loading...
