2-6 Service Manual
4022-XXX
54 Std Par ENA Connection
Lost
54 Par <x> ENA Connection
Lost
The printer has lost the connection to an external print
server (also called an external network adapter or ENA).
Make sure the cable connecting the ENA and the printer
is securely attached. Turn the printer off and then on to
reset the printer. Press Go to clear the message. The
printer erases any reference to the ENA and then resets.
56 Serial Port <x> Disabled
56 Standard Serial Disabled
Data has been sent to the printer through a serial port,
but the serial port is disabled. Press Go to clear the
message. The printer discards any data received
through the serial port. Make sure the Serial Buffer
menu item in the Serial Menu is not set to Disabled.
56 Parallel Port <x> Disabled
56 Std Parallel Port Disabled
Data has been sent to the printer through a parallel port,
but the parallel port is disabled. Press Go to clear the
message. The printer discards any data received
through the parallel port. Make sure the Parallel Buffer
menu item in the Paralled Menu is not set to Disabled.
56 USB Port <x> Disabled
56 Standard USB Port Disabled
Data has been sent to the printer through a USB port,
but the USB port is disabled. Press Go to clear the
message. The printer discards any data received
through the USB port. Make sure the USB Buffer menu
item in the USB Menu is not set to disabled.
57 Configuration Change The printer cannot restore confidential or held jobs on
the hard disk because the print configuration has
changed.
Note: The messages 57 Configuration Change and Held
Jobs May Not Be Restored alternate on the display.
58 Too Many Disks Installed Too many hard disks are installed on the printer. The
printer only supports one hard disk at a time. Turn off
and unplug the printer. Remove the excess hard disks
from the printer. Plug in the printer and turn it on.
58 Too Many Flash Options Too many flash memory options are installed on the
printer. Turn off and unplug the printer. Remove the
excess flash memory. Plug in the printer and turn it on.
58 Too Many Trays Attached Too many drawers with matching trays are installed on
the printer. Turn off and unplug the printer. Remove the
additional drawers. Plug in the printer and turn it on.
61 Defective Disk The printer detects a defective hard disk. Press Go to
clear the message and continue printing. Install a
different hard disk before you perform any operations
that require one.
62 Disk Full There is not enough memory on the hard disk to store
the data sent to the printer. Press Go to clear the
message and continue processing. Any information not
previously stored on the hard disk is deleted. Delete
fonts, macros, and other data stored on the hard disk.
User Error Message Explanation
To Next Page
Loading...
