3-16 Service Manual
4025-XXX
Input Tray Sensor Test
Use this test to determine whether or not the input tray sensors are working correctly. To
run the test, select the Sensor Test operation from the INPUT TRAY TESTS menu.
The Power indicator blinks while the page is being fed.
If Single is selected, no buttons are active during the feed test. However, if Continuous is
selected, Return or Stop can be pressed to cancel the test.
<input tray> represents the input source selected for the Print Test. One of the following
sources display: Tray 1, Tray 2, Tray3, Tray 4, Tray 5, MP Feeder, or Env Feeder.
To exit the sensor test, press Return or Stop.
Output Bin Tests
Output Bin Feed Test
The Feed Test operation within the OUTPUT BIN TESTS menu is used to verify that
media can be fed to a specific output bin. No information is printed on the feed test pages
since the laser isn’t engaged during this test.
Note: The feed test can be run using any of the paper and envelope sizes supported by
the printer.
Media is fed from the default input source, and the Feed Tests menu lets a user select the
output bin. Each of the installed bins is listed as an option within this menu. For each bin,
the user has two choices:
• Single (feed one sheet of media),
• Continuous (continue feeding media until Return or Stop is pressed).
While the page is being fed, the following message is displayed. The Power indicator
blinks while the page is being fed.
If Single is selected, no buttons are active during the feed test. However, if Continuous is
selected, Return or Stop can be pressed to cancel the test. While the test is being
cancelled, the following message is displayed.
Note: <output bin> represents the output bin selected for the Feed Test. One of the
following bins is displayed: Standard Bin, Output Bin 1, Output Bin 2, Output Bin 3,...,
Output Bin 10.
<output bin>
Feeding...
<output bin>
Cancelling...
To Next Page
Loading...
