Repair Information 4-71
4025-XXX
Exit Drive Assembly
Removal
1. Remove the Offset Assembly.
2. Remove the three screws securing the Exit Drive Assembly to the Offset Assembly.
3. Pull the Exit Drive Assembly straight out and away from the Offset Unit.
Replacement
1. Align the Exit Drive Assembly with the Offset Assembly so the white drive gear and
shaft fit through the corresponding opening in the Exit Drive Assembly.
2. Press the Exit Drive Assembly onto the Offset Assembly, slightly repositioning the
Exit Drive Assembly so the positioning pin on the upper right side of the Offset
Assembly fits through the corresponding hole in the Exit Drive Assembly. Make sure
you do not trap any wire harnesses between the Exit Drive Assembly and the Offset
Assembly.
3. Use three screws to secure the Exit Drive Assembly to the Offset Assembly.
4. Reinstall the Offset Assembly.
To Next Page
Loading...
