1-76 Service Manual
4025-XXX
Paper jam A sheet of paper stops at a point along the paper path
Paper path The path a sheet of paper takes from the paper feeder to the
output tray
P/H Paper Handling
P/J Plug and Jack. Electrical connectors as a unit
PL Parts List
PPM Pages Per Minute or Prints Per Minute
Pre-Reg Pre-Registration
Print cycle The printer creating and delivering one finished print
Print surface The side of a sheet of paper that receives the printed image
PS Power Supply
PWB Printed Wiring Board (sometimes referred to as PCB or
Printed Circuit Board)
R
R Right
Reg or Regi Registration
R/H Right Hand
ROM Read Only Memory
RTN Return
S
Sensor A device used to monitor a function or operation, such as
paper travel along the paper path
SG Signal Ground
Signal name A name assigned to a wire, indicating the purpose of the wire
and/or the voltage carried by that wire
SNR Sensor
SOL Solenoid
SOS Start Of Scan
STA Status
STS Soft Touch Sensor
SW Switch
T
Temp Temperature
Test Print A grid pattern print that is generated by the MCU
Test Print Mode The mode of operation that lets you generate a test print
Toggle To switch between two states, such as on and off or up and
down
Toner The dry ink that is used to create the visible image. Toner is
stored in the EP Cartridge
Transfer Moving the toner image from the surface of the drum to the
surface of a sheet of paper
V-
VVolts
VAC Volts - Alternating Current
To Next Page
Loading...
