Repair information 4-23
7013-XXX
Fax card removal
1. Remove the rear door and cover. See “Rear door and cover removal” on page 4-69.
2. Remove the right side printer cover. See “Right side printer cover removal” on page 4-73.
3. Remove the two screws (A) securing the fax card to the printer frame.
4. Disconnect the cable (B) from the controller board.
5. Remove the fax card.
CAUTION
This product contains a lithium battery. THERE IS A RISK OF EXPLOSION IF THE BATTERY
IS REPLACED BY AN INCORRECT TYPE. Discard used batteries according to the battery
manufacturer’s instructions and local regulations.
To Next Page
Loading...
