Repair information 4-47
7100-XXX
Waste toner auger removal
1. Remove the photodeveloper cartridge. See “Photodeveloper cartridge removal” on page 4-8.
2. Remove the transfer belt unit. See “Transfer belt unit removal” on page 4-5.
3. Remove the top cover assembly. See “Top cover assembly removal” on page 4-10.
4. Remove the transfer belt cleaning roller. See “Transfer belt cleaning roller removal” on page 4-4.
5. Remove two screws (A) from the waste toner auger; remove the waste toner auger.
Waste toner agitator removal
1. Remove the waste toner auger. See “Waste toner auger removal” on page 4-47.
2. Remove gear (A) from the cleaning roller clutch.
3. Pull the agitator off the shaft; lift and remove.
A
A
To Next Page
Loading...
