3-4 Service Manual
7100-XXX Lexmark confidential until announce edited 1/4/2007
Maintenance mode
Maintenance mode contains information and settings that can be used in servicing the X5xx series MFPs.
The maintenance mode menu is entered by holding down the key when performing a POR. The various
items in maintenance mode are accessed by using the and keys to navigate within a submenu to
each item, and pressing the to select the item. Press the
key to move up a level.
WARNING: These settings should not be used without the supervision of your secondary support center.
Display info
The default menu displayed when in maintenance mode is the Display info menu. To select this menu item,
press the key. The Display info menu item contains printer-specific information. The information in this
menu is described below. Press to exit this menu.
Model Name
Model Name is the default menu item in the Display info submenu.This item displays the MFP model
name. The options are X500, and X502. This item cannot be changed. Press to exit this item.
FW Version
The FW Version submenu displays three different firmware related items. While in the Display info menu,
use the and keys to navigate to FW Version and press the key to enter the submenu. FW
Version menu items are accessed by using the and keys to navigate within the submenu to each
item.
CTL FW Ver
CTL FW Ver displays the system board firmware version. It cannot be changed in the menu. This is the
default menu item in the FW Version submenu. Press to exit this item.
Fax FW Ver
The second item is Fax FW Ver which displays the fax firmware version. It cannot be changed in the menu.
Press to exit this item.
MCTL FW Ver
The third item is MCTL FW Ver which displays the engine controller board firmware version. It cannot be
changed in the menu. Press to exit this item.
Press to go back up to the Display info menu.
To Next Page
Loading...
