4-36 Service Manual
7100-XXX
System board removal
Warning: Before replacing the system board, save the onboard settings. See “Printing the maintenance
and configuration pages” on page 3-3.
Warning: When replacing the System/RIP board, be sure to set the country code. See “Setting the
country code” on page 3-3.
1. Disconnect any attached USB or network cables.
2. Remove the left rear cover. See “Left rear cover removal” on page 4-16.
3. Remove the screw (A) securing the system board cover.
4. Remove the system board cage cover.
CAUTION
There is a lithium battery on your system board. RISK OF EXPLOSION IF REPLACED BY
AN INCORRECT TYPE. The battery is non-replaceable. Do not replace, recharge,
disassemble, or incinerate a lithium battery. Discard used batteries according to the country,
state or local regulations.
A
To Next Page
Loading...
