Lexmark X502N - Low Voltage Power Supply (LVPS) with Cage Removal

4-40 Service Manual
7100-XXX
Low voltage power supply (LVPS) with cage removal
1. Remove the transfer belt unit. See “Transfer belt unit removal” on page 4-5.
2. Remove the RIP board cage. See “System board cage removal” on page 4-38.
3. Remove the grounding terminal screw (A).
4. Disconnect the power supply bracket connector (B).
5. Remove three screws (C) that attach the power supply bracket; remove the power supply bracket.
6. Remove the screw (D), and disconnect all the connectors from the LVPS.
7. Remove three metal screws (E) and 3 plastic screws (F) that attach the LVPS with the cage; remove
the LVPS with the cage.
AB
D
CC
EFF