1-16 Service Manual
7100-XXX
Serial number
Look for serial number information on the right cover and the inside of the front cover of your MFP.
Tools required for service
The removal and adjustment procedures described in this manual require the following tools and
equipment:
• Analog volt ohmmeter (A digital volt ohmmeter may also be used.)
• Flat-blade screwdrivers
• Needle-nose pliers
• #1 Phillips screwdriver
• #2 Phillips screwdriver
• Slotted screwdriver #1
• Slotted clock screwdriver #1
• Tweezers, C-ring pliers
When you make voltage readings, always use frame ground unless another ground is specified.
To Next Page
Loading...
