Diagnostic information 2-57
7100-XXX
Ribbing service check
Light print occurs in right or left side of image.
Problem area Action
1 Printer is not level Table printer is sitting on is slightly tilted.
Tilt should be less than 1/2 inch.
Confirm the printer table is large enough and the printer is
level.
2 Toner cartridge insufficient amount of toner in the toner cartridge.
Shake the toner cartridge horizontally several times to level
the toner.
3 Toner cartridge Toner in the toner cartridge is not level and collects on one
side.
Shake the toner cartridge horizontally several times to level
the toner. If problem persists, replace toner cartridge.
4 Rear cover assembly Open rear cover assembly, and close properly.
5 Photodeveloper cartridge Photodeveloper OPC belt is off rack and becomes deformed
during operation.
Replace photodeveloper cartridge. See “Photodeveloper
cartridge removal” on page 4-8.
Note: Photodeveloper cartridge is a customer order supply.
To Next Page
Loading...
