Phone Line Busy
These are possible causes and solutions. Try one or more of the following:
CHANGE REDIAL SETTINGS
The printer automatically redials three times at 2-minute intervals. You can change the default settings to redial
up to five times at intervals up to 8 minutes.
To change the redial settings:
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Dialing and Sending appears.
6 Press .
7 To change the number of times the printer will redial:
a Press or repeatedly until Redial Attempts appears.
b Press .
c Press or repeatedly until the setting you want appears.
d Press .
8 To change the length of time between redials:
a Press or repeatedly until Redial Time appears.
b Press .
c Press or repeatedly until the setting you want appears.
d Press .
SCHEDULE TO RESEND FAX AT A LATER TIME
See “Sending a broadcast fax at a scheduled time” on page 26.
Phone Line Error
These are possible causes and solutions. Try one or more of the following:
REVIEW DIGITAL PHONE SERVICE CHECKLIST
The fax modem is an analog device. Certain devices can be connected to the printer so that digital telephone
services can be used.
• If you are using an ISDN telephone service, connect the printer to an analog telephone port (an R-interface
port) on an ISDN terminal adapter. For more information and to request an R-interface port, contact your ISDN
provider.
• If you are using DSL, connect to a DSL filter or router that will support analog use. For more information, contact
your DSL provider.
Troubleshooting
51
To Next Page
Loading...
