2-112 Service Manual
7526
900.05—Transfer module error service check
26
Are there any more ISP options to install? Go to step 27 Problem
resolved.
27
Install the next ISP option. Restart the device.
Does the 900.xx error reoccur?
Go to step 29. Go to step 28.
28
Run a job to test the option.
Does the 900.xx error reoccur?
Go to step 29. Go to step 26.
29
Upgrade the firmware. Contact your next level of
support for the correct firmware level to use.
Restart the printer to operating mode.
Does the 900.xx error reoccur?
Go to step 30. Go to step 26.
30
Replace the faulty ISP option. Restart the device.
Does the 900.xx error reoccur?
Go to step 31. Go to step 26.
31
Contact your next level of support. You will need the following information for them:
• Exact 900.xx error digits and complete error message
• Printed menu settings page
• Printed network settings page
• Device error log
• A sample print file if error appears to be isolated to a single file
• File/Application used if error is related to specific print file
• Device Operating System
• Driver used (PCL/PS)
• Frequency of the occurrence of the error
Step Questions / actions Yes No
1 1. Turn the printer off.
2. Remove the rear frame cover. See “Rear
frame cover removal” on page 4-37.
3. Check the transport cable in connector
JTPS1 for proper connection to the
system board, cable pinch points, and any
other damage to the cable or connector.
Is the cable damaged?
Replace the transport
cable. See “Transport
cable removal” on
page 4-190.
Go to step 2.
2
Replace the transfer module.
Did the error clear?
Problem resolved. Replace the system board.
See “System board
removal” on page 4-165.
Step Action and questions Yes No
To Next Page
Loading...
