Diagnostic information 2-129
7526
3
1. Open the right cover.
2. Reseat the motor driver cable on the
motor driver side (A).
3. Reseat all cables connected to the motor
driver card.
Does this clear the error?
Problem resolved. Go to step 4.
4
Connect a new motor driver cable from
outside of the machine.
Note: Make sure to verify first if the motor
driver cable is working properly by connecting
one end to the motor driver card, and the
other end to the JDVR1 connector on the
system board. Route the cables properly only
when you have verified that the cable is
working properly.
Does this clear the error?
Replace the motor driver
cable See “Motor driver
cable removal” on
page 4-125.
Go to step 5.
5
Connect a new transport motor cable.
Did this clear the error?
Return the original part
from the printer and
replace the transport motor
cable. See “Transport
motor cable removal” on
page 4-193.
Go to step 6.
6
Connect a new motor driver card.
Did this clear the error?
Return the original parts of
the printer and replace the
motor driver card. See
“Motor driver card
removal” on page 4-126.
Go to step 7.
7
1. Connect a new EP drive assembly from
outside of the machine.
2. Transfer the motor driver card and cables
to the new EP drive assembly and
connect the cables.
Did this clear the error?
Replace the EP drive
assembly and connect the
original parts back to the
machine. See
“Electrophotographic
(EP) drive assembly
removal” on page 4-86.
Replace the system board.
See “System board
removal” on page 4-165.
Step Questions / actions Yes No
To Next Page
Loading...
