4-70 Service Manual
7526
Contact springs kit removal
See “Contact springs kit” on page 7-11 for the part number.
Toner cartridge contacts removal
1.
Remove the LVPS. See “Low-voltage power supply (LVPS) removal” on page 4-123.
2. Remove the printhead. See “Printhead removal, installation, and adjustment” on page 4-148.
3. Remove contact spring cables from the cable restraints (A).
Note: Pay attention to the routing of the cartridge contact cables, and the appropriate slots where each
cartridge contact is installed.
To Next Page
Loading...
