Lexmark X748dte - Option Cable Removal

4-136 Service Manual
7526
Go Back
Previous
Next
8. Pry the sensor off the bracket, then disconnect the sensor (C) from the cable (D).
9. Remove the cable from the bracket.
Installation note: Pay attention to the routing of the cable.
Option cable removal
1. Remove the LVPS. See “Low-voltage power supply (LVPS) removal” on page 4-123.
2. Disconnect the cable connector at JOPT2 (A) on the system board.
3. Replace the rear frame cover to protect the system board.
C
D