4-198 Service Manual
7526
5. Flip open the lock on the UICC cable, then disconnect the cable from the connector.
6. Remove the UICC cable.
Installation note: Pay attention to the routing of the UICC cable. and make sure it is properly connected to the
UICC connector.
USB connector cable removal (front panel)
1. Remove the top access cover. See “Top access cover assembly removal” on page 4-40.
2. Place the top access assembly on a soft lint-free cloth with the touchscreen facing down.
3. Remove the six smaller screws (A) securing the position guide cover.
To Next Page
Loading...
