Lexmark X792 7562-4xx - XX-Magenta Cartridge Motor Error Service Check

Diagnostic information 2-91
7562
Go Back
Previous
Next
143.xx—Magenta cartridge motor error service check
Step Questions / actions Yes No
1 Turn the printer off, open the system board
shield, and remove the RIP card shield.
Check the cable in the connector JCM1 for
proper connection to the system board.
Is the cable properly connected?
Go to step 2. Reseat the cable.
2
Check the cable for damage.
Is the cable damaged?
Replace the BLDC C&M
cable. See “EP drive
assembly removal” on
page 4-54.
Go to step 3.
3
Measure the resistance across the fuse F9 on
the system board.
Is the fuse blown?
Replace the system board.
See “System board
removal” on page 4-150.
Go to step 4.