2-36 MFP Service Manual
7500-XXX
986.00
Service
finisher error
Sensor (eject clamp HP) on
failure
The sensor (eject clamp HP) is not turned on within
500 ms after the eject clamp up starts.
Refer to the Options Service Manual.
986.01
Service
finisher error
Sensor (eject clamp HP) off
failure
The sensor (eject clamp HP) is not turned off within
200 ms after the eject clamp down starts.
Refer to the Options Service Manual.
987.00
Service
finisher error
Sensor (media eject shaft
HP) on failure
The sensor (media eject shaft HP) is not turned on
within 200 ms after the set clamp starts operating.
Refer to the Options Service Manual.
987.01
Service
finisher error
Sensor (media eject shaft
HP) off failure
The sensor (media eject shaft HP) is not turned off
within the specified time after the set clamp ends
operating.
Refer to the Options Service Manual.
988.00
Service
finisher error
Sensor (punch unit side
reg 1) on failure
Sensor (punch unit side
reg 2) on failure
The sensor (punch unit side reg 1) or sensor (punch
unit side reg 2) did not detect the media correctly or
is defective.
Refer to the Options Service Manual.
988.01
Service
finisher error
Sensor (punch unit side
reg 1) off failure
Sensor (punch unit side
reg 2) off failure
The sensor (punch unit side reg 1) or sensor (punch
unit side reg 2) did not detect the media correctly or
is defective.
Refer to the Options Service Manual.
989.00
Service
finisher error
Stapler unit failure The off/on status of the sensor (stapler unit motor
HP) is not detected within the specified time after
the stapler unit motor (forward operation).
Or the sensor (stapler unit motor HP) is not turned
on within the specified timer after the stapler unit
motor is on (reverse operation).
Refer to the Options Service Manual.
990.00
Service
finisher error
Sensor (stapler carriage HP)
on failure
The sensor (stapler carriage HP) is not turned on
within two seconds after the stapler starts moving
toward the staple position, and also the sensor
(stapler carriage HP) is turned off.
Or the sensor (stapler carriage HP) is not turned on
after the stapler was moved to the staple position.
Or the sensor (stapler carriage HP) is turned off
again after the sensor (stapler carriage HP) is
turned on, and the stapler stopped its moving.
Refer to the Options Service Manual.
990.01
Service
finisher error
Sensor (stapler carriage HP)
off failure
The sensor (stapler carriage HP) is not turned off
within 500 ms after stapler starts moving to the
staple position, and sensor (stapler carriage HP) is
turned off.
Or the sensor (stapler carriage HP) is not turned off
after the stapler was moved to the staple position.
Or the sensor (stapler carriage HP) is turned on
again after the sensor (stapler carriage HP) is
turned off, and the stapler stopped its moving.
Refer to the Options Service Manual.
Error code or
message
Error contents Description/Action
To Next Page
Loading...
