Lexmark X850E - RIP Card Assembly Communication Failure; Media Tray 1 Lift up; no Media Tray Failure

2-166 MFP Service Manual
7500-XXX
939.00 RIP card assembly communication failure
941.00 Media tray 1 lift up / no media tray failure
4 Perform a print test.
Does the error continue?
Replace the
printer engine card
assembly.
Go to “Printer
engine card
assembly
removal” on
page 4-117.
Problem solved.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Go to step 3. Problem solved.
3 Check the RIP card assembly connection.
Is the RIP card assembly connection JHAB2 and the printer
engine card assembly connection P402 connected
properly?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-128.
Go to step 4.
Replace the
connection.
4 Perform a print test.
Does the error still occur?
Replace the
printer engine card
assembly.
Go to “Printer
engine card
assembly
removal” on
page 4-117.
Problem solved.
Step Check Yes No
1 Check the media.
Pull out media tray 1 to visually check it.
Is media loaded in tray 1?
Go to step 2. Load media
properly.
2 Check the media tray.
Replace media tray 1 with media tray 2.
Is the replaced media tray lifted up?
Go to step 3. Go to step 4.
3 Check the media tray.
Are the tray lift sector gear 12T, of media tray 1, or
surrounding parts damaged?
Replace the media
tray lift sector gear
12T or other
damaged
components.
Go to step 4.
Step Check Yes No