Diagnostic information 2-219
7500-XXX
7 Check the laser beam route.
Check for debris between the transfer roll assembly and
the PC drum.
Check the printhead assembly window for
contamination.
Is there any debris in the laser beam route or the
printhead assembly window?
Go to step 8. Remove debris,
or clean the
transfer roll
assembly
window.
8 Check the heat roll and pressure roll.
Remove the fuser unit assembly.
Warning: Allow the fuser unit assembly to cool down.
Is there contamination or cracks on the heat roll and/or
pressure roll?
Replace the
fuser unit
assembly.
Go to step 9.
9 Check the printer engine card assembly.
Replace the printer engine card assembly.
Perform a print test.
Does the error continue?
Problem solved. Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-128.
Step Check Yes No
To Next Page
Loading...
