2-224 MFP Service Manual
7500-XXX
After image
The ghost appears on the media which, may be the image from the previous page or part of the page
currently printing.
Step Check Yes No
1 Check the media condition.
Load new, dry, recommended media.
Re-print the defective image.
Does the error continue?
Go to step 2. Problem solved.
2 Check the toner cartridge.
Install a new toner cartridge.
Re-print the defective image.
Is the image density normal?
Problem solved. Go to step 3.
3 Check the heat roll and the pressure roll.
Remove the fuser unit assembly.
Caution: Allow the fuser unit assembly to cool down.
Is there contamination or cracks on the heat roll and/or
pressure roll?
Replace the
fuser unit
assembly.
Go to step 4.
4 Check the printer engine card assembly.
Replace the printer engine card assembly.
Perform a print test.
Does the error continue?
Problem solved. Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-128.
Leading edge
Trailing edge
To Next Page
Loading...
