4-2 MFP Service Manual
7500-XXX
Removal procedures
CAUTION: Remove the power cord from the printer or electrical outlet before connecting or
disconnecting any cable or electronic board or assembly for personal safety and to prevent
damage to the printer. Disconnect any connections between the printer and PCs/peripherals. The
MFP weighs approximately 70 kg (154 lb) and requires at least four people to lift it safely. Make
sure your fingers are not under the MFP when you lift or set it down.
Parts removal and replacement procedures are described in this chapter.
Note: Parts are controlled as spare parts. When servicing parts for which no procedure is described,
observe the assembly before starting the service.
Note: Though the optional parts are assumed to be removed, they may not be removed if not required for
the purpose of service.
Before starting service work
CAUTION: While performing service around the fuser assembly, ensure the fuser area has cooled down.
Note: A wide variety of screws are used; make note of their positions during service.
To Next Page
Loading...
