4-318 MFP Service Manual
7500-XXX
Exit 2 diverter gate removal
1. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-315.
2. Open the exit 2 unit assembly.
3. Remove two screws securing the upper guide assembly (A) to the exit 2 unit assembly.
4. Remove the upper guide assembly (A).
Note: The exit 2 access handle (B) may become detached.
5. Remove the spring (C) connecting the exit 2 diverter gate (D) to the upper guide assembly (A).
6. Gently flex the mounting points securing the exit 2 diverter gate (D) to the upper guide assembly (A).
7. Remove the exit 2 diverter gate (D)
Note: After reinstalling the upper guide assembly (A), ensure the exit 2 access handle (B) operates freely.
Boss
A
Front
A
B
C
D
To Next Page
Loading...
